Professionally designed mosfet for airsoft electric guns. The device increases weapon cadence and battery life over the original wiring in the weapon. Fully integrated device inside the V3 mechabox instead of the original trigger contacts according to Tokio Marui standard. Finished wiring adapted for the battery above the mechabox with DeanT connector - no need to solder anything.

- Built-in mosfet on switch contacts from SHS

- Easy installation inside the V3 mechabox

- Complete wiring allows quick and easy installation into the weapon, designed for all types of AK-type weapons with battery located above the mechabox

- Power wires with thin and rigid MPPE insulation with a cross section of 1.5 mm2 (AWG16), mmblue wire with a cross section of 0.34 mm2 (AWG22) with MPPE insulation

- Electronics board coated with lacquer to protect against water ingress into the device

- Designed for all types of commonly used batteries up to 17V (Ni-xx 8.4 - 12V, Lipol 7.4 - 14.8V)

Weight: 30g

Voltage at LiPo: 7.4V - 14.8V

Voltage at NiMH: 8.4V - 12V

Gearbox version: V.3