The Perun V2 Hybrid replaces the classic mechanical contacts in an airsoft gun and provides a number of useful features. Optical and magnetic sensors eliminate moving parts that are susceptible to damage, increasing reliability. Adaptive trigger control allows switching from short trigger pull to long trigger pull even in the field.

Installation is with most V2 mechaboxes (Tokyo Marui standard) without the need for any modifications. Please refer to the manual for details and exceptions.

FEATURES

Trigger Sensitivity - The trigger sensitivity can be adjusted in 5 levels of sensitivity, from very short travel to very long travel. No trigger or mechabox adjustment is required. Changing the trigger sensitivity is also possible in the field.
Independent firing switch programming - program the firing modes however you want, by setting safe/semi/auto on both switch positions.
Active brake - allows you to stop the engine after each shot. In case of double shot problem in high cadence guns, active brake is an effective solution. It can also prevent unnecessary spring compression - the plunger remains in the forward position between shots. You can turn the active brake off or on in seconds.
Pre-cocking the piston - a quick trigger reaction can be the difference between winning or losing, especially in CQB. When piston preload is activated, the piston will remain in the recoil position after each shot with the spring already compressed, ensuring that the next shot will be fired immediately after the trigger is pulled. To release the spring after using the preload, press and hold the trigger for 2 seconds, then a second shot will be fired, this time without preload.
2-position trigger - a light squeeze of the trigger fires the gun semi (or burst), a full squeeze burst (or auto). Available modes: semi - burst, semi - auto and burst - auto.
Double shot mode - allows you to set two shots in semi-auto mode. When this scheme is enabled, the gun will fire not only when the trigger is pulled, but also when it is released.
Cadence Reduction - Reduces cadence in auto or burst mode for more realistic gun behavior and reduced ammunition consumption.
DMR mode - provides intervals between semi-automatic shots to comply with DMR rules on some ranges.
Battery Protection - Battery protection mode is designed for Li-Po and Li-Ion batteries. If the battery voltage drops below a critical level, the user is alerted by short audible beeps repeated every minute (the alert can be turned off).
DSG - a piston gear detection mode specifically designed for double piston gears.
Diagnostics - the processor constantly monitors the state of the gun and the mosfet itself. In the event of any problems, it will immediately alert you to the malfunction, making troubleshooting much easier.
Electronic safety - saves your gun and battery in the event of a serious malfunction. It will automatically disconnect the battery when a short circuit or locked motor is detected.
Programming of all settings is done entirely by quick and easy to remember firing switch and trigger press sequences. The current status is confirmed by audible signals and a multi-coloured LED. This allows you to change settings at any time, within seconds, even under enemy fire. All settings are set separately for each firing switch position, so you can program the mosfet exactly the way you want - for example, semi to semi and binary trigger to auto.

The Perun V2 Hybrid works seamlessly with any battery from 7 to 17 volts, there is a Dean-T connector on the cable.

The Perun V2 Hybrid has been tested by the manufacturer in the mechabox of the following manufacturers:
A&K, Bolt, Classic Army, G&G (with some exceptions), G&P, ICS, JG, King Arms, KWA (gen 2.0, 2.5+ and 3.0+), Retro Arms, Specna Arms, Ultimate and VFC. For Cyma, G&G G2 and Krytac mechaboxes, mechabox modifications are required. Check the manual for exact compatibility information.

Weight: 20g